Although I'll be talking to Danny in the next day or two, I wanted to publicly thank him for being patient with me while I awaited the delivery of my glass chipper. He's a first class guy.
Now, a question for those of you that use glass chippers. When creating those scalloped edges, are there any hints that you care to share in the use of the glass chipper. Spacing secrets, techniques, depth of blade or screw settings. Any suggestions or words of wisdom would be greatly appreciated.
I almost got a test piece done when, with three chips left to do on the end, I let too much of the glass hang over the workbench and it broke in half while I was doing a chip. Darn, it was looking pretty nice for a first piece. Lesson learned, don't let any more glass hang over the edge than is necessary to create the chip.
Welcome to The Hand Lettering Forum!
This is an interactive Bulletin Board on the topics of Sign making, design, fabrication, History, old Books and of coarse Letterheads, Keepers of the craft. The Hand Lettering Forum features links to resources, sign art history, techniques, and artists profiles. Learn more about Letterheads at https://theletterheads.com. Below you'll see Mchat has been added as a live communication portal for trial, and the Main forum Links are listed below.
This is an interactive Bulletin Board on the topics of Sign making, design, fabrication, History, old Books and of coarse Letterheads, Keepers of the craft. The Hand Lettering Forum features links to resources, sign art history, techniques, and artists profiles. Learn more about Letterheads at https://theletterheads.com. Below you'll see Mchat has been added as a live communication portal for trial, and the Main forum Links are listed below.
Thank You to Danny Baronian and a question
Moderators: Ron Percell, Mike Jackson, Danny Baronian
-
- Posts: 76
- Joined: Thu Apr 08, 2004 9:07 am
- Location: Boise, Idaho
Thank You to Danny Baronian and a question
Dennis Davis
Boise, Idaho
Boise, Idaho
-
- Posts: 1077
- Joined: Fri Apr 09, 2004 9:29 am
- Location: Ottawa Canada
- Contact:
-
- Posts: 101
- Joined: Thu May 13, 2004 10:53 am
- Location: Burnaby, British Columbia, Canada
- Contact:
-
- Posts: 58
- Joined: Mon Apr 25, 2005 12:57 am
- Location: Tooele, UT
- Contact:
I've noticed that the angle of the cut makes a big difference when using a nipper. For best results the surface of the edge should be perpendicular to the surface of the glass, and that 90 degree angle should be consistant along the entire edge. If this angle changes, the nipper won't be biting the same amount of glass each time, and the size of the chip changes. I've heard that using an oiled cutter makes a more accurate perpendicular cut, but I'm not sure if this is true.