Welcome to The Hand Lettering Forum!
This is an interactive Bulletin Board on the topics of Sign making, design, fabrication, History, old Books and of coarse Letterheads, Keepers of the craft. The Hand Lettering Forum features links to resources, sign art history, techniques, and artists profiles. Learn more about Letterheads at https://theletterheads.com. Below you'll see Mchat has been added as a live communication portal for trial, and the Main forum Links are listed below.

Glue chip glass

Hand Lettering topics: Sign Making, Design, Fabrication, Letterheads, Sign Books.

Moderators: Ron Percell, Mike Jackson, Danny Baronian

Post Reply
Robert Schwieger
Posts: 123
Joined: Wed Feb 07, 2007 12:38 pm
Location: Nebraska

Glue chip glass

Post by Robert Schwieger »

Advice needed. Having completed approximately 75% of a glass piece chipping, the humidity and heat were interrupted for 10 hours. Which is the preferred method to resume chipping? Simply resume the process or remove glue and apply new glue to unchipped area with proper heat and humidity. This is a matter of utilizing time and labor. Your observations are welcomed. Bob
Larry White
Posts: 1213
Joined: Thu Apr 08, 2004 4:18 am

Post by Larry White »

I'd just put it out in the sun. It should all chip off. However, having the rest chip in a different environment could cause the chip pattern to be different. Perhaps first try resuming the process that was interupted.

-LW
Doug Bernhardt
Posts: 1077
Joined: Fri Apr 09, 2004 9:29 am
Location: Ottawa Canada
Contact:

Post by Doug Bernhardt »

Agreed.
Mike Jackson
Site Admin
Posts: 1705
Joined: Tue Apr 06, 2004 11:02 pm
Location: Jackson Hole, WY
Contact:

Post by Mike Jackson »

Robert,
Please come back to the post and let us know how the glass is doing.

We may have additional suggestions if your piece still won't finish chipping.

Mike Jackson
Mike Jackson / co-administrator
Golden Era Studios
Vintage Ornamental Clip art
Jackson Hole, WY

Photography site:
Teton Images
Jackson Hole photography blog:
Best of the Tetons
Robert Schwieger
Posts: 123
Joined: Wed Feb 07, 2007 12:38 pm
Location: Nebraska

Post by Robert Schwieger »

Hello. As advised, I simply continued the process with the original glue in place. Worked fine. My concern has been expressed by so many when we live in an area that has relatively high humidity. Seldom below 50 per cent. For smaller pieces, such as the current one, I use a tent affair (Box) over a room humidifier. It appears that the humidity is controlled and the unit produces heat which helps the process. Appreciate the kind advice. Thanks again. Bob
DAVE SMITH
Posts: 1213
Joined: Sat Jul 10, 2004 11:12 am
Location: ENGLAND

Post by DAVE SMITH »

Hi Robert.
Back when I was experimenting with chipped glass I used to place the glass with the glue already dried into a double glazed sealed unit with desicant spread around the edges.
Basically two pieces of glass sealed with an inch trim 4ft by 5ft air tight it used to work very well.I also have high humidity here next to the coast,it can be a pain. Get yourself that lightbox I was talking about you won'nt get any further problems.
Dave
Post Reply