Sorry to post this here but I need some help. If their is one else out there with a Graphtec fc5100 plotter I would like to know what condition setting ( It suggest #4) you use for thick sandblast mask and what the condition setting are set at.
Thanks
Roderick
Welcome to The Hand Lettering Forum!
This is an interactive Bulletin Board on the topics of Sign making, design, fabrication, History, old Books and of coarse Letterheads, Keepers of the craft. The Hand Lettering Forum features links to resources, sign art history, techniques, and artists profiles. Learn more about Letterheads at https://theletterheads.com. Below you'll see Mchat has been added as a live communication portal for trial, and the Main forum Links are listed below.
This is an interactive Bulletin Board on the topics of Sign making, design, fabrication, History, old Books and of coarse Letterheads, Keepers of the craft. The Hand Lettering Forum features links to resources, sign art history, techniques, and artists profiles. Learn more about Letterheads at https://theletterheads.com. Below you'll see Mchat has been added as a live communication portal for trial, and the Main forum Links are listed below.
Graphtec plotter
Moderators: Ron Percell, Mike Jackson, Danny Baronian
-
- Posts: 1086
- Joined: Sat Apr 10, 2004 8:04 pm
- Location: San deigo Calif
- Contact:
-
- Posts: 68
- Joined: Thu Apr 15, 2004 3:17 pm
- Location: Mendocino, California
- Contact:
Re: Graphtec plotter
Condition 4 34
6
Ready 4
CB15Ux 0
6
Ready 4
CB15Ux 0
Mendocino, California
"Where the redwoods meet the Sea"
"Where the redwoods meet the Sea"