After a peice is mirrored and has the art work apllied (backed up) I've been useing silver strip to remove the silver thats not backed up.Is there a formula mixture that removes the silver and yet will not harm the edges of the backed up silver.I'm thinking maybe my mix (from Sarah) might be to strong?Or is there somthing else to use?
I've notice that one of my samples has a little bit of tarnishing on the edge of the silver.The sample was rinsed with clean water and painted out with one-shot so it's totally sealed.
Roderick
Removing mirroring
Moderators: Danny Baronian, Mike Jackson, Ron Percell
-
- Posts: 1048
- Joined: Sat Apr 10, 2004 8:04 pm
- Location: San deigo Calif
- Contact:
-
- Posts: 1140
- Joined: Thu Apr 08, 2004 4:18 am
Backing up silver...
Rod-
Be careful what you use to back up the silver. Many products will cause it to tarnish. Might I suggest using a mirror back up paint, or asphaltum varnish. When using silver strip, I prefer to moisten a paper towel with it and rub it over the area. If you allow it to puddle at the paint edge, it can undercut slightly. -LW
Be careful what you use to back up the silver. Many products will cause it to tarnish. Might I suggest using a mirror back up paint, or asphaltum varnish. When using silver strip, I prefer to moisten a paper towel with it and rub it over the area. If you allow it to puddle at the paint edge, it can undercut slightly. -LW
-
- Posts: 415
- Joined: Thu May 06, 2004 11:18 am
- Location: Milwaukee
- Contact:
Silver Removal
Have you tried to dilute the silver strip?
I seem to remember doing that...I think I even mixed in some bon ami, by wiping the damped diluted silver strip rag across a bon ami bar a swipe or two...and then going after the unbacked up silver.
RMN
I seem to remember doing that...I think I even mixed in some bon ami, by wiping the damped diluted silver strip rag across a bon ami bar a swipe or two...and then going after the unbacked up silver.
RMN
Who is online
Users browsing this forum: No registered users and 7 guests